Hardware Only, Not including Door Panel -Material:Stainless steel 304 -Surface:satin -Track's length should be twice of the door panel. The height from top of the door to the top of the roller is about 130mm, pls make sure you have at least 150mm for installation -The space between door and wall is about 16mm based on door panel thickness:16mm -Hardware's suitable for door panel thickness:40/45mm -Two rollers can bear weight 90kgs -Track has been pre-drilled 16" apart holes, if your wall is drywall+stud, pls check if it's 16" between two studs! -Two ends of track has been pre-drilled screws holes for track connector to make two short one to be a long track for double door. 5ft/5.5ft single door kit's including.12FT Double door kit's including. 8ft single door kit's including. The height from top of the door to the top of the roller is 130mm(5 3/25"), please at least 150mm(6") for installation The gap between door and wall is 16mm(16/25") based on door thickness 40mm(1 4/7") Door panel need to be cut a groove for floor guide, Groove Height:1"Width:3/5" Step 1: Drill wall Locate and mark the holes for the five flanges used to install the rail.
Be sure to align your markings with the level before drilling. Step 2: Attach the rail to the wall Attach the rail with the flanges and screws provided.Note: If you havent removed the mouldings, you will need longer screws than those supplied (not included). Step 3: Attach the single bearing supports Trace the exact position of the supports and pre-drill the holes before installing the supports on the door. Step 4: Install the jump-proof devices Install the two jump-proof devices, as illustrated. Step 5: Install the door and adjust jump-proof devices Place the assembled door on the rail. Reposition the two jump-proof devices by rotating them so that they are completely on the edge of the door.
Step 6: Install the floor guide Mark the thickness of the door (Y) on the floor, approximately 1 cm (13/32) from door opening, on the side where the door will slide. Use a level to make sure the lines are parallel to the wall.Step 7: Door bumpers If needed, adjust the position of the bumpers installed during step 2. The bumpers will prevent the door from sliding off the rail when the installation is complete. If you find any missing or demage on the products pls take me outer package photo and demaged products photo ASAP, we will try our best to solve it. 8/10/12ft Industrial Wheel Double Sliding Barn Wood Door Track Hardware.
DIYHD Two side Soft close Barn Door Hardware Big Spoke Wheel Barn Door Track Kit. 8ft Sliding barn door wood door hardware rustic black barn sliding track. White Color Straight Country Style Sliding Barn Wood Door Track Hardware Kit. 5ft-8ft sliding barn door top mount stainless steel hardware safety pin wheel.
The item "5-12ft Brushed Nickel steel sliding barn wood door hardware sliding barn track" is in sale since Friday, April 08, 2016. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware". The seller is "sliding-barn-door" and is located in Carol Stream,IL. This item can be shipped to United States.